Abc-office Finisher 4300 Bedienungsanleitung

OPERATINGINSTRUCTIONSFINISHER 4300Model No. BA-FS43Banner American Products, Inc.abcoffice 800-658-8788 www.abcoffice.com

Cleaning Rubber Rollers:Excessive build-up of adhesive on the rollers may cause poor lamination quality and erratic film movement.Use the following pr

X. Trouble-shooting...Symptom Possible Cause Corrective ActionLCDs do not show display No power to laminator Close panel breakerwhen heat switches are

XI. Laminating & Mounting Do’s and Don’ts...Read the instruction manual before operating your laminator.Always run test samples before laminat

Table of ContentsI. For Your Safety ... 2II. Electrical Safeguards...

Finisher 4300 (BA-FS43)SPEEDCONTROLTOPBOTTOMTEMPERATURECONTROLBOTTOMHEATSHOETEMPERATURECONTROLTOPHEATSHOE1010FORWARDREVERSEFANSMOTORHEATHEATEDROLLERSC

u Do not connect the laminator to electrical power or attempt to operate it until you have readthese instructions completely. Keep these instructions

u Do not operate the laminator with a damaged power supply cord or plug.u Replace fuses only with same type rated 30A, 240V and 1A, 250V fuses. Conta

Threading the Film (Figures 1&2)1. Feed the film from the top roll behind the upper idler roller rod and lay it over both heat shoes. Be surethat

Slitters (Figure 4):To install the slitters, place the Main Body Clamps into the Top Roller Guard where they will slide into the slotsin the in the to

VI. Pressure Sensitive Laminating...Note: You must have the Rewind Option for Pressure Sensitive Films in order to laminate withpressure sensitive mat

VIII. Mounting & Laminating...1. Be sure all laminator parts (i.e. safety shield, feed table, etc.) are in their proper positions and the laminat-